ขอวิธีลง อิมเมจ cloud ibox ด้วยครับ อยากได้ทั้ง 2 วิธีครับ
ทั้งแบบ
- DCC ผ่านสายแลน (ไม่มีสาย RS232)
- USB (วิธีแบบ ภาษาไทยนะครับ)
* ขอบคุณล่วงหน้าครับ
เท่าที่ทราบ
การลง ใช้ USB เท่านั้นครับ
ส่วนการลงผ่านโปรแกรม เคยลองทำ แต่ไม่สำเร็จ และเป็นโปรแกรมของ vu solo (ไม่ใช่ DCC ครับ)
ระหว่างลง firmware สีของไฟที่หน้าจอ อาจแตกต่างจากคำบรรยายภาษาอังกฤษ
และเมื่อลงเสร็จ จะมีทั้งแบบที่ต้อง ปิด เปิด เครื่องเอง
และบาง image เมื่อลงเสร็จ จะ auto reboot ให้อัตโนมัติ (ลงเสร็จ ภาพมาทันที แบบที่ผมลงให้)
How to update VU solo by USB
Extract the downloaded file to a folder on our computer.
Inside the compressed archive will be present the following three files:
1.root_cfe_auto.jffs2
2.kernel_cfe_auto.bin
3.boot_cfe_auto.jffs2
The USB key must create a specific directory:
The files go in a vuplus/solo/ directory from the root of the USB stick. You then put the USB stick in the front USB port on the SOLO, then turn on mains power and you should get:
ORANGE/RED LIGHT (CONSTANT) IN ROUND DISPLAY WINDOW - LED LIGHT FLASHING ON USB STICK (if yours has an LED)
after a min or two you'll then get
ORANGE/RED LIGHT FLASH IN ROUND DISPLAY WINDOW - NO FLASHING FROM LED ON USB STICK
then just a short while later
GREEN LED FLASHING IN ROUND DISPLAY WINDOW - NO FLASHING FROM LED ON USB
That's it, you can now remove the USB stick and turn the mains power off then back on. Once you turn the power back on again the green LED in the display window should be constant and it'll just be a black screen on the TV, you must wait a good while now, longer than you'd imagine, then eventually the VU+ setup wizard screen will appear and you are good to go!
Seems fairly obvious really now that stage one is transfer info from USB stick, stage two flash from memory, stage three complete!